So, I've just got my o2 the Analog Video Module. Problem is, I use SETENV -P from the PROM to set videotiming, videoinput, videooutput, and videogenlock to what seems like it should be a valid configuration for my setup per the higherintellect writeup and the O2Video man page but I only receive videostatus=av_error in response.
I've tried updating my IRIX 6.5.22 install using Booterizer's overlaid discs but suspect I may need something off the base 6.5 set.
EDIT: So, I popped the cover off my existing audio input module for some comparisons...and I apparently was sold a audio module without the cover for the composite and S-video inputs, which are both populated on the audio only board for some reason. Both 1145-001 Rev. D, same spots on the board populated with the same chips. Be sure to check for that MooseCam connector, folks.
I've tried updating my IRIX 6.5.22 install using Booterizer's overlaid discs but suspect I may need something off the base 6.5 set.
EDIT: So, I popped the cover off my existing audio input module for some comparisons...and I apparently was sold a audio module without the cover for the composite and S-video inputs, which are both populated on the audio only board for some reason. Both 1145-001 Rev. D, same spots on the board populated with the same chips. Be sure to check for that MooseCam connector, folks.
Last edited: