Octane drive sleds

Elf

All gone now
Feb 4, 2019
794
264
63
Edit: With apologies, I no longer wish to have involvement with SGUG or SGI communities in general,
and have also chosen to remove all of my content. Many things have changed since I co-founded, named, and ultimately
then left SGUG. There are many good people around, to whom I apologize for frustrating by removing these things, and
also many petty people that over the years whittled down both the enjoyment as well as sense of obligation I used to
feel to anyone else regarding what was ultimately just a hobby. Unfortunately one of the latter now writes the rules
and so it is time for me to take my things and go.

This message will replace all of my previous forum posts because deleting threads that I started would have removed
other peoples' posts.
 
Last edited:
What I probably need the most is the dimensions of the thickness of the handle (on the sides). The other important measurements I need are the radius of the peg that holds the drives in, and the distance to the center of that peg (perhaps measured from the center of the drive screw hole like I have in the picture?_
 

Attachments

  • SRef4uW.png
    SRef4uW.png
    30.9 KB · Views: 375
Edit: With apologies, I no longer wish to have involvement with SGUG or SGI communities in general,
and have also chosen to remove all of my content. Many things have changed since I co-founded, named, and ultimately
then left SGUG. There are many good people around, to whom I apologize for frustrating by removing these things, and
also many petty people that over the years whittled down both the enjoyment as well as sense of obligation I used to
feel to anyone else regarding what was ultimately just a hobby. Unfortunately one of the latter now writes the rules
and so it is time for me to take my things and go.

This message will replace all of my previous forum posts because deleting threads that I started would have removed
other peoples' posts.
 
Last edited:

About us

  • Silicon Graphics User Group (SGUG) is a community for users, developers, and admirers of Silicon Graphics (SGI) products. We aim to be a friendly hobbyist community for discussing all aspects of SGIs, including use, software development, the IRIX Operating System, and troubleshooting, as well as facilitating hardware exchange.

User Menu