One drive showing up as multiple

draconpern

New member
May 22, 2024
9
0
1
The drive is 36GB, did a netinstall but after install a bunch of duplicate units show up that reference the system root. How do I remove them?

24-05-22 02-13-30 0569.jpg
 
Check your hinv output. See if they show up there. If so, you probably need to terminate the drive bus with either a physical terminator or a jumper or resistor pack on the drive, whichever it has. If not, check your FAM setup and look at the Desktop entries to see if they are valid.
 
So it turns out the drive id can't be 0. Setting to 1 fixed the issue. Want to note that it had nothing to do with bus termination.
 
Last edited:

About us

  • Silicon Graphics User Group (SGUG) is a community for users, developers, and admirers of Silicon Graphics (SGI) products. We aim to be a friendly hobbyist community for discussing all aspects of SGIs, including use, software development, the IRIX Operating System, and troubleshooting, as well as facilitating hardware exchange.

User Menu