Hi all,
I'm not sure why but my 4-port Extron VGA switcher doesn't seem to be picking up the VGA signal from my V12 Octane. If I run a cable direct to the monitor it works, but it just isn't detecting a signal. Res is 1920x1200@60. If I put the Octane into my Extron DVS 304 scaler, it works and outputs DVI - but honestly I prefer to just go via VGA because the Extron scaler isn't 100% perfect, the fonts/output seem to be a bit aliased/blurry, I tried the pass-through setting but it doesn't work.
Anyway this is more about my Extron VGA switcher. This DID used to work, but in recent times it just started to become unreliable. I opened up the switcher to inspect and found that on the PSU board the 22uf 400v capacitor was leaking, so I replaced it. Unfortunately this didn't fix the problem - the switcher works with all my other VGA devices though, so I think it's working ok.
Any thoughts?
Cheers.
I'm not sure why but my 4-port Extron VGA switcher doesn't seem to be picking up the VGA signal from my V12 Octane. If I run a cable direct to the monitor it works, but it just isn't detecting a signal. Res is 1920x1200@60. If I put the Octane into my Extron DVS 304 scaler, it works and outputs DVI - but honestly I prefer to just go via VGA because the Extron scaler isn't 100% perfect, the fonts/output seem to be a bit aliased/blurry, I tried the pass-through setting but it doesn't work.
Anyway this is more about my Extron VGA switcher. This DID used to work, but in recent times it just started to become unreliable. I opened up the switcher to inspect and found that on the PSU board the 22uf 400v capacitor was leaking, so I replaced it. Unfortunately this didn't fix the problem - the switcher works with all my other VGA devices though, so I think it's working ok.
Any thoughts?
Cheers.